Automatic cutting table overview:

Automatic cutting table commonly known as slitting machine, is an intelligent flexible coil slitting equipment, through microcomputer programming control of the whole machine workflow, the long width of adhesive tape protective film and self-adhesive material slitting into any width of products. This type of equipment has extremely high cutting precision, can cut products as low as 0.5mm wide, cutting accuracy up to ±0.02mm.

Automatic cutting table classification: automatic cutting table also known as automatic roll cutting machine, automatic rubber cutting machine, automatic cutting machine, automatic cutting machine and other names, can be divided into single-axis automatic cutting table, two-axis automatic cutting table, four-axis automatic cutting table and eight-axis automatic cutting table;

According to the different feeding methods can be divided into oil feed automatic cutting table, servo feed automatic cutting table, so far, oil feed cutting table due to high maintenance costs, speed control mode is single and other drawbacks, basically eliminated.

Single axis cutting table is characterized by a wide range of slitting products, round. Knife, flat knife, serrated knife can be installed and used, relative to multi-axis cutting table is low production efficiency; Although the production efficiency of the two-axis and four-axis fixed cutting table and the four-axis and eight-axis automatic switching cutting table is doubled compared with the single-axis cutting table, the range of processing materials is limited to the scuttling of ordinary packaging tape, electrical tape and some electronic tape, and the accuracy is not as high as that of the single axis.

The tail seat support of the cutting spindle of the single-axis automatic cutting table is roughly divided into three kinds of structures, closed-door pneumatic support - up-down pneumatic support - vertical lifting pneumatic support. The first two structures are the most common, and the defect is that when cutting large-diameter materials or adhesive products with higher hardness, the spindle will produce slight shaking, resulting in uneven end faces of the cutting products, hair, double knife and other undesirable phenomena, which are commonly seen in protective film, gold finger (PI) tape, green silicone and other materials. The vertical lift type heavy tail seat fundamentally prevents the occurrence of such problems. The disadvantages of this structure are complex processing, high production costs, and exclusive patent design, which is estimated to be difficult to popularize in a short time.

Automatic cutting table heavy tailstock

Automatic cutting table servo feed features:

1. Smooth feed.

2. Feed stroke positioning correction is convenient and safe.

3. Can automatically determine the volume diameter of the cut material and automatically set the cutting stroke of the cutter seat.

4. During the cutting process, the cutting knife feed speed is automatically adjusted to adapt to the different processing standards of the cut materials.

5. Feed speed runner manual adjustment function is convenient for new product cutting test.

Automatic cutting wheel manual speed regulation

The Angle function of the automatic cutting table: When cutting large size coils, the correct use of the appropriate positive and negative Angle swing Angle function is an essential process for cutting edge materials

Automatic cutting table safety protection:

1. Air pressure protection function; That is, when the air pressure is less than 4KG, the machine automatically alarms and automatically stops, so it will not cause safety accidents due to low air pressure

2. Cutting spindle support protection function: when the tail seat is fully closed, the device can be started normally. Therefore, when the tail seat is not closed or not completely closed, all operation keys of the device are in the stop state, and the man-machine interface will automatically prompt alarm. If the tail seat is abnormally loose during the working process, the machine will automatically emergency stop and alarm to prevent safety accidents.

3. Round knife protection function: Due to the unreasonable setting of round knife and spindle speed ratio and feed speed, the round knife motor will automatically stop when overloaded during operation, which can effectively prevent safety accidents caused by round knife damage. (There are many reasons for the damage of the round knife, not to be detailed)

Scope of use of automatic cutting table (single axis standard) :

1. Discharge width range: within 1350mm

2, discharge diameter range: Φ300mm

3, cutting width as low as: 0.5mm

4, cutting precision: ±0.05mm

5, use voltage: 380V 50HZ

Non-standard products can be designed and manufactured according to material processing technology standards.